AC Un Installation & Installation Service

✔ Uninstallation Process

✔ Unit Removal – Carefully detach indoor & outdoor units without damage

→ Preserve all components (brackets, pipes, wiring)

→ Protect walls/floors during removal

✔ Electrical Disconnect – Turn off power and remove wiring safely

→ Label wires for easy reinstallation

→ Insulate exposed wire ends

✔ Refrigerant Recovery – Extract remaining gas (EPA-approved)

→ Store gas properly for reuse

→ Zero environmental leakage

✔ Site Cleanup – Leave space ready for new unit

→ Remove old mounting hardware

→ Patch wall holes (optional)

✔ Installation Process

✔ Unit Placement – Install indoor and outdoor units with proper spacing

→ Level indoor unit for optimal drainage

→ Outdoor unit with 12+ inches airflow clearance

✔ Electrical Setup – Safe wiring with dedicated power

→ New circuit breaker if needed

→ Waterproof connections

✔ Piping Work – Connect and insulate copper pipes

→ Pressure-test for leaks

→ Vacuum-seal refrigerant lines

✔ Testing – Verify perfect operation

→ Check cooling performance

→ Adjust airflow direction

Products We Used

🔧 Uninstallation Products

✔ 1. Sealing & Protection

→ Copper Pipe Caps – Airtight seal for refrigerant lines

→ PVC Drain Plugs – Prevent water leakage after disconnection

→ Insulation Tape – Protect exposed pipe ends

✔ 2. Gas Recovery

→ Refrigerant Recovery Machine – Extracts R32/R410A gas

→ Storage Cylinders – Holds recovered refrigerant safely

✔ 3. Hardware Removal

→ Bracket Removal Tools – For stainless steel mounts

→ Wall Anchors – Reusable if undamaged

✔ 4. Site Cleanup

→ Wall Patch Cement – Fills drill holes (optional)

🔩 Installation Products

✔ 1. Mounting Hardware

→ New Stainless Steel Brackets – Heavy-duty support

→ Rubber Vibration Pads – Noise reduction

✔ 2. Piping & Insulation

→ Pre-Insulated Copper Pipes – 1/4" & 3/8" sizes

→ Armaflex Insulation – Prevents condensation

✔ 3. Electrical

→ Circuit Breaker – Dedicated 15-20A power line

→ Waterproof Wire Connectors

✔ 4. Testing & Finishing

→ Vacuum Pump – Removes air/moisture

→ Leak Detection Spray – Checks connections